MOLD SEAL AND CORE PASTE

Exochem Corporation has brought molding processes to a new age.  One that keeps up with the fast pace demanded by all industries today and reaches previously unobtainable levels of effectiveness and efficiency.  Exochem Corporation's Mold Seal is a continuous beading cope and drag sealant that's easy and fast to apply to help eliminate runout.  It is placed on the outside edges of the casting cavity in the drag prior to closing the mold.  When the cope is placed on the drag, the mold seal compresses to a super thin film to maintain the dimensional accuracy of the casting during all four seasons.  Mold Seal will not harden until the heat from the casting comes in contact with it.  Then it becomes an adhesive developing in excess of 200 lbs tensile per square inch.  During shakeout, the mold seal can be recycled with the spend molding sand.  And it can be utilized with all current sand binders.

Consult with your Exochem representative on the application method that will best suit your foundry's needs.

EPC-120

Our all-purpose, high-strength ready-to-use adhesive which is ready for pouring in two hours. EPC-120 Core Paste has a long working time and becomes water and heat resistant after drying.  For use on all core types and available to you in convenient 5-gallon pails or easy-to-pour drums.

EPC-HS

An excellent paste for hot-shell cores or oil sand cores right out of the oven.  EPC-HS is available in easy-to-pour drums or 5 gallon pails.

EPC-FS

Our fastest bonding paste for use with all core binders.  EPC-FS features high initial "tack" and rapid air drying.  EPC-FS is water resistant after drying and is available to you in handy plastic dispensers.  Total cure in 15 minutes.